Bondtech drive gear kit in hardened and surface protected steel.
Super sharp teeths for maximum grip on the filament.
The perfect choice for a high-performance feeding system.
Extremely high wear resistance for use with abrasive filaments.
These drivegear kits come as a set consisting of a primary drive gear, a secondary drive gear, bearings and a shaft. There are two kits available:
- 1.75/5.0 - Gear set for filament size 1.75 mm, primary gear with inner diameter 5 mm, secondary gear with two needle bearings,M3x2 setscrew and one 3 x 20 mm shaft.
- 1.75/8.0 - Gear set for filament size 1.75 mm, primary gear with inner diameter 8 mm, secondary gear with integrated needle bearings, M4x3 setscrew and one 4 x 22 mm shaft.
A Lithium based grease is recommended to use on the gear section and inside the needle bearings for low friction and to avoid wear. A small dab of grease is enough.