- 750W 120V
- 3M Adhesive Backing
- NTC 100K Thermistor
- 4 pre-made holes
DIY products do not include support, or warranty fulfillment from Tiny Machines 3D. Technical support will be handled by the manufacturer. These products are new unless otherwise specified.
Notes from Keenovo
- Heaters may get super hot. Please handle with care.
- Red wires are the Thermistor sensor extension wires, white wires are for voltage supply to the heating element.
- A supporting frame/layer is strongly suggested to have the heating element "sandwiched" tightly for better heating result. Please kindly check this post about a Perfect Installation.
- If your heater does not come with a Keenovo Digital controller, you may want to wire it via an SSR, please kindly check this post on SSR Wiring.
- If your heater comes with Keenovo Digital Controller, please read the Controller Configuration Manual, especially the "Advanced Setting" part, carefully BEFORE making any changes on the controller.
- The controller unit is 100% brand new. Yet due to manufacturing reasons, stains, dusts or scratches may be present on the silicone case. It may also fit less tight as shown in the picture. Please consider this before the purchase.
- As we receive customer feedback, we do make small alterations to our products if we feel they improve the their performance and stability. The item(s) you receive might reflect some of these slight changes and improvements.
- Do not cut the heater.